SWINGARM AND DRIVE CHAIN
2. Check:
_
Do not attempt to straighten a bent pivot
shaft.
3. Wash:
4. Check:
EAS00709
CHECKING THE DRIVE CHAIN
1. Measure:
NOTE:
_
• While measuring the 15-link section, push
• Measure the length between drive chain
• Perform this measurement at two or three
4 - 84
• pivot shaft
Roll the pivot shaft on a flat surface.
Bends → Replace.
WARNING
• pivot shaft
• dust covers
• spacer
• bushing
• bearings
Recommended cleaning solvent
Kerosene
• dust covers
• spacers
• oil seals
Damage/wear → Replace.
• bearings
• bushings
Damage/pitting → Replace.
• a 15-link section a of the drive chain
Out of specification → Replace the drive
chain.
15-link drive chain section limit
(maximum)
240.5 mm (9.47 in)
down on the drive chain to increase its ten-
sion.
roller 1 and F as shown.
different places.
CHAS