Yamaha XT660R Service Manual page 213

1 b
a
1
2
4. Install:
• left handlebar switch 1
NOTE:
_
Align the projection a on the left handlebar
switch with the hole b in the handlebar.
5. Install:
• clutch lever
• clutch lever holder 1
a
NOTE:
_
Align the mating surfaces of the clutch lever
holder with the punch mark a on the handle-
bar.
6. Install:
• throttle grip 1
• throttle cables 2
• right handlebar switch 3
1
• grip end
NOTE:
_
• Lubricate the inside of the throttle grip with a
• Route the throttle cables through the slot in
• Align the projection a on the right handlebar
3
• There should be 1 ~ 3 mm (0.04 ~ 0.12 in) of
b
a
7. Install:
• throttle cable holder
_
Make sure the throttle grip operates
C
smoothly.
4 - 67
HANDLEBAR
7 Nm (0.7 m · kg, 5.1 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
thin coat of lithium-soap-based grease and
install it onto the handlebar.
the right handlebar switch, and then install
the cables.
switch with the hole b in the handlebar.
clearance c between the throttle grip and
the grip end.
WARNING
CHAS