Extraordinary Maintenance; Removing The Door; Replacing The Light Bulb; Removing The Door Seal - Smeg Oven Instructions For Use Manual

10. EXTRAORDINARY MAINTENANCE

The oven requires periodic minor maintenance or replacement of parts subject to wear, such as gaskets,
light bulbs, etc. Specific instructions for each operation of this kind are given below.
Before any intervention that requires access to live parts, disconnect the appliance from the
power supply.
WARNING: For your safety, you are advised to wear protective gloves while performing any
cleaning or extraordinary maintenance.

10.1 Removing the door

1. Open the door fully and lift
levers near the two hinges.

10.2 Replacing the light bulb

If a light bulb needs to be replaced because it is worn or burnt out,
unscrew the bulb cover. Remove the bulb by unscrewing it and
then replace it with a similar bulb (25W).

10.3 Removing the door seal

To permit thorough cleaning of the oven, the door seal may be
removed.
There are fasteners on all four sides to attach it to the edge of the
oven. Pull the edges of the seal outwards to detach the fasteners. The
seal must be replaced when it loses elasticity and hardens.
Instructions for the user
2. Grasp the door on both
sides with both hands, lift
it forming an angle of
around 30° and remove it.
3. To reassemble the door, put the
hinges into the relevant slots in the
oven, making sure
sections are resting completely in the
slots. Lower the door and disengage
the lock levers.
EN
that grooved
21