Sharp SJ-H511K-T Operation Manual page 8

Installation
Select a location.
1
Position your refrigerator so that the plug is accessible.
Do not place next to heat generating appliance.
Keep your refrigerator out of direct sunlight.
Do not place directly on the ground. Provide a clean, level, firm floor surface such as concrete or timber.
Place a sturdy board in the case of following:
Do not place directly on a carpet as this
will cause the intake port on the bottom
of the refrigerator to become blocked.
To ensure adequate ventilation for your refrigerator, it is
2
recommended to provide space of 6cm on both sides and
at the back, and space of 9cm above the refrigerator.
Insufficient spacing will decrease the cooling efficiency,
resulting in unnecessary consumption of electricity.
Fix to a sturdy wall or pillar to
3
prevent the refrigerator from
falling over.
Use the hole
for passing
ropes.
9cm or more
6cm or more
6cm or more
Using the two front Adjustable feet, ensure that the
4
refrigerator is positioned firmly and level on the floor.
Installing on unstable surface will cause vibration and noise.
Pull out and remove the
Foot cover.
Turn the adjustable feet on both
sides until they reach the floor.
(Adjust so that the refrigerator
becomes level)
Attach the Foot cover.
Carpet
Air
Notes
Do not place objects on top
of the refrigerator.
Electric room is located on top of
the refrigerator.
Storing objects on top of the
refrigerator may lead to its failure.
Audio and video noise may be
noticed on radios, televisions, etc.
when using near the refrigerator.
Move radios, televisions, etc. to
a location where audio and video
noises are not noticed.
Do not install screws, etc.
on the refrigerator.
6cm or more
Cooling circuit (pipes) may
become damaged as a result.
Electric room
Foot cover
Right/left
adjustable foot
45