Sharp SJ-H511K-T Operation Manual page 13

Refrigerator-freezer
Table of Contents

Advertisement

Warming
To cancel operation
Press "Select" for more than 2 seconds.
The Warming lamp goes OFF.
Temperature zone selection compartment switches to "Cooling" mode.
The temperature zone selection compartment will not immediately reach the Cooling zone.
(It will take approximately 30 minutes. The LCD panel will show "
Notes
To change the Warming period or extend the Warming period during Warming operation.
Set up the period within 15 minutes after
Warming completion (cancel).
(It will go into the "Do not operate warmer
function mode" after 15 minutes.)
The extension period becomes shorter
depending on the previous Warming
operation period as shown on the right.
(This product can operate continuously for
no longer than 8 hours.)
This product cannot operate Warming continuously over 8 hours.
(To prevent temperature increase in other compartments)
When it completes 8 hours of Warming operation,
it will go into the "Do not operate warmer function"
for approximately 2 hours.
("Do not operate warmer function" also works
from 15 minutes after Warming completion
less than 7 hours to 2 hours later.)
To change the Warming temperature during warming operation.
Cancel the operation once and set up the period again (Within 15 minutes after canceling).
Notes
Do not store food materials with containers whose
outer surface temperatures are 100°C or higher.
The temperature zone selection compartment case
may become deformed by the heat.
If the Warming operation and defrosting operation are
successively carried out, the temperatures of the other
compartments may become slightly high temporarily.
However this will not affect the food storage qualities.
The temperature zone selection compartment
temperature will not be immediately cool even when
the temperature zone is selected immediately after
Warming completion (cancel). Leave approximately
30 minutes before using "Wine room," "Fresh Case,"
and "Cooling" modes and approximately 1 hour before
"Crunchy Freezing" and "Freezing" modes.
50
(Continued)
The previous Warming operation period
Do not operate warmer function
If you try to set up Warming
operation, there will be a beep and
the control panel will not accept the
setup operation. It will show the
approximate period until the next
Warming setup will be possible.
Warming of beverages
Hot only products can be kept under Warming operation.
Do not keep the following products under Warming operation:
Glass-bottled beverages, carbonated beverages,
beverages in resin containers ... It may cause container
deformation.
Beverages containing milk, vegetable or juice constituents
... It may cause the constituents to deteriorate.
Do not keep beverage in containers from which it has
been sipped directly under Warming operation.
It may promote the bacteria from mouth to multiply in the bottle.
Do not keep beverages under Warming repeatedly.
Reheating of a cooled beverage may lead to ingredient
deterioration or bacterial multiplication.
".)
Up to 1 hour
~
1 hour
2 hours
~
2 hours
3 hours
~
7 hours
8 hours
The figure shows that Warming
setup will be possible in
1 hour and 20 minutes.
Extension period
Up to 7 hours
Up to 6 hours
Up to 5 hours
It cannot be extended.
hr.
min.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents