Sharp SJ-H511K-T Operation Manual page 5

Warning
This refrigerator is contains flammable refrigerant (R600a: isobutane) and insulation
blowing gas (cyclopentane).
Observe the following rules to prevent ignition and explosion.
The refrigeration system behind and inside the refrigerator contains refrigerant. Do not allow any sharp
objects to come into contact with the refrigeration system.
Do not use electric appliances inside the refrigerator.
Use only the specified lamp for the refrigerator compartment.
Do not block the openings on the circumference of the refrigerator.
If the refrigeration system should get punctured, do not touch the wall outlet and do not use open flames.
Open the window and air out the room.
Then ask a service agent approved by SHARP for servicing.
This refrigerator should be disposed appropriately. Take the refrigerator to a recycling plant for flammable
refrigerant and insulation blowing gases.
Securely ground the unit.
Electrical shock may occur as a result.
Use belt, etc. to prevent the refrigerator from
falling over.
Bodily injury from the refrigerator falling over during
an earthquake, etc. may result.
When cleaning any areas adjacent to electrical
components, unplug the refrigerator first to prevent
electric shock.
To prevent accidental power disconnection, plug the
refrigerator directly to the source.
Do not use a double adaptor as loss of power
could lead to the spoiling of the stored food.
Do not push the refrigerator against the power plug.
The plug may become damaged, causing excessive
heating/ignition as a result.
Dust deposited on the power plug may cause fire.
Wipe it off carefully.
42
Installation
Power supply and power plug / cord
In the case abnormality (burning smell, etc.) is
noticed, remove the power plug and stop use.
Electrical shock and/or fire may occur as a result.
For repair, call the Sharp Service Center.
Do not attempt to change or
modify this refrigerator.
This may result in fire,
electric shock or injury.
Cleaning
When cleaning your refrigerator, do not splash
water directly on the outer cabinet or the interior.
This may lead to rusting and deterioration of the
electrical insulation.
Do not use other than AC220 ~ 240V.
Electrical shock and/or fire may occur as a result.
When disconnecting the power plug, do not touch
the pin of plug.
This may cause electric shock.
Securely insert the power plug.
Abnormality