Recording - Sharp XL-60H Operation Manual

RECORDING

When recording important selections, be sure
to make a preliminary test to ensure that the
desired material is being properly recorded.
The ALC (Automatic Record Level Control) cir-
cuit automatically controls the level of the input
signal used for recording.
The VOLUME, BASS and TREBLE controls may
be adjusted with no effect on the recorded sig-
nal. (Variable Sound Monitor)
Metal and CrO tapes should not be used for
2
recording.
Recording from the built-in CD player
(CD Synchronised Recording System)
1
5
2
1
Press the ON/STAND-BY button to turn the
power on.
2
Press the FUNCTION button until "CD" or "NO
DISC" appears in the display.
3
Load the desired disc.
Use the APMS function to store the tracks you
want to record in memory. (See page 15.)
4
Load a cassette into the cassette compartment.
5
Press the REC PAUSE button.
"REC" will flash.
6
Press the 0 button.
To stop recording:
Press the button.
The tape will stop. When the
again, the CD will stop.
When you press the CD
control, the CD and tape will stop.
*60H/70H(SUK)23-27
1
6
2
3
Note:
4
4
To stop recording:
Press the
1
2
3
button is pressed
button on the remote
27
27
Recording from the built-in radio
3
Tune in to the desired station. (See pages 17 -
18.)
Load a cassette into the cassette compartment.
Press the REC PAUSE button.
"REC" will flash.
If a whistling noise is heard whilst recording from
an AM station, move the AM loop aerial to a po-
sition where noise is minimised.
Press the 0 button.
button.
Erasing a recorded tape
Press the FUNCTION button until "TAPE" ap-
pears in the display.
Press the REC PAUSE button.
"REC" will flash.
Press the 0 button.
00.1.5, 11:41 AM
4
2