Sharp XL-60H Operation Manual page 26

(Continued)
EON-TI
4
1
Tune in the desired RDS station (when a sta-
tion name is being displayed.)
2
Press the EON button when "EON" appears.
"PTY TI" will flash for about 4 seconds.
3
Whilst they are being displayed, select the TI
(Traffic Information) using the jog dial.
The selected "TI" will flash.
4
Within 4 seconds, press the PTY.TI SEARCH
button.
"TI" and "WAITING" will appear for 2 seconds
each.
"TI" will appear, and the unit will enter the EON-
TI stand-by mode.
*60H/70H(SUK)23-27
5
When a TA specified starts on an ON (other
network) station, the unit will automatically
switch to that station, and "TI" will flash.
6
When the traffic announcement is over, the unit
2
will automatically return to the original station
you were tuned to.
Note:
3
If the EON button is pressed when "EON" is not
displayed, "NO EON" will appear for 4 seconds
to indicate that the unit cannot enter the EON
stand-by mode.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON
button. ("TI"
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON
button. Within 4 seconds, press it again. The EON
stand-by mode will be cancelled.
"TI" will go out.
Note:
If neither "TP" nor "TA" appear, then even if "EON"
appears the unit cannot enter the EON-TI stand-
by mode. In this condition, even if the EON but-
ton is pressed, "NO TI" will flash for 4 seconds.
25
25
"WAITING")
00.1.5, 11:41 AM