Setting The Clock - Sharp XL-60H Operation Manual

SETTING THE CLOCK

(Main unit operation)
In this example, the clock is set for the 24-hour
(0:00) system.
MEMORY/SET
CLOCK/TIMER/
SLEEP
1
Press the CLOCK/TIMER/SLEEP button to en-
ter the time check mode.
2
Within 3 seconds, press the MEMORY/SET but-
ton.
3
Turn the jog dial to select the time display mode.
0:00
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is
first installed or it has been reset (see page 31).
4
Press the MEMORY/SET button.
5
Adjust the hour by turning the jog dial.
When the jog dial is turned one click clockwise,
the time will increase by 1 hour. When it is turned
one click anti-clockwise, the time will decrease
by 1 hour.
Keep turning the jog dial to change the time con-
tinuously.
When the 12-hour display is selected, "AM" will
change automatically to "PM".
*60H/70H(SUK)08-12
6
7
Jog dial
8
Note:
AM 12:00
To change the clock time:
Perform steps 1, 2 and 4 - 8 above.
To change the time display mode:
1
2
12
12
Press the MEMORY/SET button.
Adjust the minutes by turning the jog dial.
When the jog dial is turned one click clockwise,
the time will increase by 1 minute. When it is
turned one click anti-clockwise, the time will de-
crease by 1 minute.
Keep turning the jog dial to change the time con-
tinuously.
The hour setting will not advance even if min-
utes advance from "59" to "00".
Press the MEMORY/SET button.
The clock starts operating from "0" second. (Sec-
onds are not displayed.)
In the event of a power failure or when the AC
power lead is disconnected, the clock display will
go out.
When the AC power supply is restored, the clock
display will flash on and off to indicate the time
when the power failure occurred or when the AC
power lead was disconnected.
If this happens, follow the procedure below to
change the clock time.
Perform steps 1 - 3 in the section "RESETTING
THE MICROCOMPUTER", on page 31.
Perform steps 1 - 8 above.
00.1.5, 11:39 AM