Manual Cooking - Smeg Oven General Instructions Manual

5.5

Manual cooking

The manual program is "P40" and can be edited by the user, but does not save
the cooking parameters set in memory. To select this program proceed as
follows:
• Save the program temporarily, as described in chapter 5.3 Editing / saving a
program. Unlike saved programs, the cooking time can even be set to
infinite; the display will show the text "InF".
• After saving it, do NOT return to the "OFF" condition. Press the "START"
button. The appliance will perform a pre-heating cycle, showing the text
"PrEh" on the display.
• When preheating is finished, a series of beeps lasting 3 seconds indicate
that is possible to proceed with the cooking operation. The text "PrEh" will
flash on the display.
• To start the cooking, keep the "START" button pressed for 2 seconds. The
display will show, in order, the set cooking parameters.
• It is possible to start cooking early before the preheating temperature is
reached, by keeping the "START" button pressed for 3 seconds.
• The operating parameters can be modified during cooking, as indicated in
paragraph 5.4.2 Modifying a program during cooking.
• During the last minute of cooking, only the countdown of the remaining 60
seconds will be displayed. At the end, a beep and the text "End" flashing (for
20 minutes) will indicate that cooking has been completed.
• At the end of the cooking operation, to perform the same program again
press the "START" button once more.
• To return to the "OFF" status keep the "STOP" button pressed for 4 seconds.
The parameters set for the program are deleted.
36
Instructions for the user