4.5
The manual program is "P40" and can be edited by the user, but does not
save the cooking parameters set in memory. To select this program
proceed as follows:
•
Save the program temporarily, as described in chapter 4.3 Editing /
saving a program. Unlike saved programs, the cooking time can be
set to infinite; the display will show the text "InF".
•
After saving it, do NOT return to the "OFF" condition. Press the
"START" button. The appliance will perform a pre-heating cycle,
showing the text "PrEh" on the display.
•
When preheating is finished, a series of beeps lasting 3 seconds
indicate that is possible to proceed with the cooking operation. The
text "PrEh" will flash on the display.
•
To start the cooking, keep the "START" button pressed for 2 seconds.
The display will show, in order, the temperature set, the time
remaining until the end of cooking and the program selected.
•
It is possible to start cooking early before the preheating temperature
is reached, by keeping the "START" button pressed for 3 seconds.
•
During cooking, it is possible to modify the temperature by turning the
knob to the
after 3 seconds.
•
During the last minute of cooking, only the countdown of the
remaining 60 seconds will be displayed. At the end, a beep and the
text "End" flashing (for 20 minutes) will indicate that cooking has been
completed.
•
At the end of the cooking operation, to perform the same program
again press the "START" button once more.
•
To return to the "OFF" status keep the "STOP" button pressed for 4
seconds. The parameters set for the program are deleted.
26
Instructions for the User
Manual cooking
or
symbols; it will continue with the new setting