Smeg Oven General Instructions Manual page 10

5.3 Editing / saving a program
The oven has 38 programs that can be modified by the user (from P01 to P38).
To set the operational parameters of a program:
1 Turn the knob to the
save / edit.
2 Keep the "PUSH" knob pressed for 3 seconds: the display will show the
cooking temperature.
3 Turn the knob to the
4 Press the "PUSH" knob: the display will show the cooking time.
5 Turn the knob to the
min).
6 Press the "PUSH" knob to exit from the data setting and saving phase. The
message "PEnd" will appear on the display and the parameters will be
saved.
7 After 3 seconds the display will show the parameters set in rotation.
8 To return to the "OFF" status keep the "STOP" button pressed for 4 seconds.
5.4 Running a program
From the "OFF" status proceed as follows:
1 Turn the knob to the
programs from P01 to P38. The display will show the parameters of the
selected program in rotation.
2 To start the program press the "START" button. The appliance will perform a
preheating cycle, showing the message "PrEh" on the display.
3 When preheating is finished, a series of beeps lasting 3 seconds indicate
that is possible to proceed with the cooking operation. The message "PrEh"
will flash on the display.
4 To start the cooking, keep the "START" button pressed for 2 seconds. The
display will show, in order, the set parameters, the time remaining until the
end of cooking and the program selected.
5 It is possible to start cooking early before the preheating temperature is
reached, by keeping the "START" button pressed for 3 seconds.
6 During the last minute of cooking, only the countdown of the remaining 60
seconds will be displayed. At the end, a beep and the text "End" flashing (for
20 minutes) will indicate that cooking has been completed.
7 To return to the "OFF" status keep the "STOP" button pressed for 4 seconds.
34
Instructions for the user
or
or
or
or
symbols to select the program you wish to
symbols to set the cooking temperature.
symbols to set the cooking time (from 1 to 99
symbols to select one of the available