User Mode 7: Warm Sleep Setting Mode - KIP STARPRINT 6000 User Giude

3. 3. 8

User Mode 7: Warm Sleep Setting Mode

This mode allows you to select Warm Sleep function.
Reference
The purpose of Warm Sleep Mode is to reduce the power consumption by falling down the
temperature of heater some degrees.
The temperature of the heater unit is about 140 degrees centigrade when the Starprint 6000
is ready. But if no print job or copy job is sent for a long time, it is better for saving the power
to fall down the temperature of heater. (Temperature is kept about 120 degrees centigrade.)
The Warm Sleep Mode will be cancelled automatically if only you send a print job or a copy
job from the outer device.
However, please understand it takes some minutes to recover from the Warm Sleep Mode
because it is necessary to raise the temperature again up to about 140 degrees.
(Print does not start until the Starprint 6000 gets ready.)
NOTE
When "ON" is selected in this User Mode 7, the Warm Sleep function can work obeying the
timer setting decided in the User Mode 6.
1) Select User Mode 7 "U7", pressing [
U 7. o n : Warm Sleep function is selected.
U 7. o F F : Warm Sleep function is cancelled.
2) Press [Enter] key in order to make this function effective then the selected setting is fixed.
(You can cancel this function with pressing [Enter] key again.)
] or [
job
TONER REMAIN
MENU
job
TONER REMAIN
MENU
3-16
] key.
IMAGE DENSITY
ENTER TEST
IMAGE DENSITY
ENTER TEST
Chapter 3 Advanced Operations