Transmitting Items - Texas Instruments TI-82 STATS Manual Book

Transmitting Items

Transmitting
Items
Stopping a
Transmission
Error Conditions
19–6 Communication Link
To transmit selected items after you have selected items to send
on the sending unit (page 19
receive (page 19 5), follow these steps.
.
1. Press ~ on the sending unit to display the
2. Confirm that
Waiting...
which indicates it is set to receive (page 19
3. Press Í to select
item are displayed line by line on the sending unit as the item
is queued for transmission, and then on the receiving unit as
each item is accepted.
After all selected items have been transmitted, the message
is displayed on both calculators. Press } and † to scroll
Done
through the names.
To stop a link transmission, press É. The
displayed on both units. To leave the error menu, select
A transmission error occurs after one or two seconds if:
A cable is not attached to the sending unit.
A cable is not attached to the receiving unit.
Note: If the cable is attached, push it in firmly and try again.
The receiving unit is not set to receive transmission.
You attempt a backup between a TI
You attempt a data transfer from a TI-82 STATS to a TI
with data other than lists
menu item
5:Lists to TI82
Although a transmission error does not occur, these two
conditions may prevent successful transmission.
You try to use
Get(
CBR.
You try to use
GetCalc(
TI-82 STATS.
4) and set the receiving unit to
.
is displayed on the receiving unit,
. The name and type of each
1:Transmit
82 and a TI-82 STATS.
-
through
L L
1 6
.
with a calculator instead of a CBL or
with a TI 82 instead of a
-
menu.
TRANSMIT
5).
.
menu is
Error in Xmit
1:Quit
82
-
or without using
.