Transmitting Items - Texas Instruments TI-83 Manual Book

Transmitting Items

Transmitting
Items
Stopping a
Transmission
Error Conditions
19-6 Communication Link
To transmit selected items after you have selected items to
send on the sending unit (page 19
unit to receive (page 19
1. Press ~ on the sending unit to display the
menu.
2. Confirm that
Waiting...
unit, which indicates it is set to receive (page 19
3. Press Í to select
each item are displayed line by line on the sending unit
as the item is queued for transmission, and then on the
receiving unit as each item is accepted.
After all selected items have been transmitted, the message
is displayed on both calculators. Press } and † to
Done
scroll through the names.
To stop a link transmission, press É. The
menu is displayed on both units. To leave the error menu,
select .
1:Quit
A transmission error occurs after one or two seconds if:
A cable is not attached to the sending unit.
A cable is not attached to the receiving unit.
Note: If the cable is attached, push it in firmly and try again.
The receiving unit is not set to receive transmission.
You attempt a backup between a TI
You attempt a data transfer from a TI-83 to a TI
data other than lists
menu item
5:Lists to TI82
Although a transmission error does not occur, these two
conditions may prevent successful transmission.
You try to use
Get(
CBL 2/CBL or CBR.
You try to use
GetCalc(
4) and set the receiving
.
5), follow these steps.
.
is displayed on the receiving
. The name and type of
1:Transmit
- 82 and a TI-83.
through or without using
L L
1 6
.
with a calculator instead of a
with a TI - 82 instead of a TI-83.
TRANSMIT
5).
.
Error in Xmit
- 82 with