Setting The Graph Modes - Texas Instruments TI-82 STATS Manual Book

Setting the Graph Modes

Checking and
Changing the
Graphing Mode
Setting Modes
from a Program
3.4 Function Graphing
To display the mode screen, press z. The default settings are
highlighted below. To graph functions, you must select
mode before you enter values for the window variables and
before you enter the functions.
The TI-82 STATS has four graphing modes.
(function graphing)
Func
(parametric graphing; Chapter 4)
Par
(polar graphing; Chapter 5)
Pol
(sequence graphing; Chapter 6)
Seq
Other mode settings affect graphing results. Chapter 1 describes
each mode setting.
or
Float 0123456789
graph coordinates.
or
Radian Degree
functions.
or
Connected Dot
functions.
or
Sequential Simul
plotting when more than one function is selected.
To set the graphing mode and other modes from a program,
begin on a blank line in the program editor and follow these
steps.
1. Press z to display the mode settings.
2. Press †, ~, |, and } to place the cursor on the mode that
you want to select.
3. Press Í to paste the mode name to the cursor location.
The mode is changed when the program is executed.
(fixed) decimal mode affects displayed
angle mode affects interpretation of some
plotting mode affects plotting of selected
graphing-order mode affects function
Func