Using The Stat List Editor - Texas Instruments TI-82 STATS Manual Book

Using the Stat List Editor

Entering a List
Name in the Stat
List Editor
To enter a list name in the stat list editor, follow these steps.
1. Display the
Name=
ways.
Move the cursor onto the list name in the column where
you want to insert a list, and then press y [
unnamed column is displayed and the remaining lists shift
right one column.
Press } until the cursor is on the top line, and then press
~ until you reach the unnamed column.
Note: If list names are stored to all 20 columns, you must remove
a list name to make room for an unnamed column.
The prompt is displayed and alpha-lock is on.
Name=
2. Enter a valid list name in any of four ways.
Select a name from the
Enter , ,
L L
1 2
Enter an existing user-created list name directly from the
keyboard.
Enter a new user-created list name (page 12.12).
3. Press Í or † to store the list name and its elements, if
any, in the current column of the stat list editor.
To begin entering, scrolling, or editing list elements, press †.
The rectangular cursor is displayed.
Note: If the list name you entered in step 2 already was stored in
another stat list editor column, then the list and its elements, if any,
move to the current column from the previous column. Remaining list
names shift accordingly.
prompt in the entry line in either of two
LIST NAMES
, , , or from the keyboard.
L L L L
3 4 5 6
]. An
INS
menu (Chapter 11).
Statistics 12–11