Using The Stat List Editor; Entering A List Name In The Stat List Editor - Texas Instruments TI-83 Manual Book

Using the Stat List Editor

Entering a List Name in the Stat List Editor

To enter a list name in the stat list editor, follow these steps.
1. Display the
Move the cursor onto the list name in the column where you want
to insert a list, and then press y 6. An unnamed column is
displayed and the remaining lists shift right one column.
Press } until the cursor is on the top line, and then press ~ until
you reach the unnamed column.
Note: If list names are stored to all 20 columns, you must remove a list
name to make room for an unnamed column.
The
Name=
TI-83 Plus Statistics
prompt in the entry line in either of two ways.
Name=
prompt is displayed and alpha-lock is on.
330