Using The Stat List Editor - Texas Instruments TI-84 PLUS - Graphing Calculator Manual Book

Guidebook
Hide thumbs Also See for TI-84 PLUS - Graphing Calculator:
Table of Contents

Advertisement

The top line displays list names.
reset. The number of the current column is displayed in the top-right corner.
The bottom line is the entry line. All data entry occurs on this line. The characteristics of this line
change according to the current context.
The center area displays up to seven elements of up to three lists; it abbreviates values when
necessary. The entry line displays the full value of the current element.

Using the Stat List Editor

Entering a List Name in the Stat List Editor
To enter a list name in the stat list editor, follow these steps.
1. Display the
Name=
Move the cursor onto the list name in the column where you want to insert a list, and then
press y 6. An unnamed column is displayed and the remaining lists shift right one
column.
Press } until the cursor is on the top line, and then press ~ until you reach the unnamed
column.
If list names are stored to all 20 columns, you must remove a list name to make room for
Note:
an unnamed column.
The
prompt is displayed and alpha-lock is on.
Name=
2. Enter a valid list name in any of four ways.
Select a name from the
Enter
,
,
L1
L2
L3
Enter an existing user-created list name directly from the keyboard.
Enter a new user-created list name.
3. Press Í or † to store the list name and its elements, if any, in the current column of the
stat list editor.
through
L1
L6
prompt in the entry line in either of two ways.
menu (Chapter 11).
LIST NAMES
,
,
, or
from the keyboard.
L4
L5
L6
are stored in columns 1 through 6 after a memory
Chapter 12: Statistics
185

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ti-84 plus silv84plseclm1l1tTi-84 plus silver editionTi-84 plus

Table of Contents