Record Settings; Time Shift And Recording Functions - Strong SRT 56 User Manual

PART 1 • English
2. Press pq buttons to select a desired recording and press oK or
bluE (u) button to playback the desired files.
3. Press EXIT button to exit.
During the playback, it is possible to perform the following actions:
Press YElloW (II) button to pause the playback.
Press the buttons for fast forward or fast rewind during playback
Press gREEn (Iu) button once to perform slow motion, every further press will
change the slow motion speed (1/2, 1/4, 1/8).
5.5.3 Removable Disk Information
In this menu you can display information about the storage device.
1. In "Media+" menu, select "Removable Disk Information" and press oK
button to enter this menu.
2. Press EXIT button to exit.

5.5.4 Record settings

This menu allows you to set the time for Timeshift, define Record Type, set Standby
Mode and Record Recovery.
1. In "Media+" menu, select Record Settings and press oK to enter this menu.
2. Press pq buttons to select a desired item and use tu buttons to
change settings.
3. Press EXIT button to exit.
Timeshift Time(min): 10/20/30/40/50/60
Record Type:
Standby Mode:
Record Recovery:

5.5.4.1 Time shift and Recording functions

Please connect your USB storage device in the correct direction to the foreseen port of your
receiver. Wait a few seconds after the sign for connected device is shown on screen then
you are ready to start Time Shift or Record for the broadcasted programme.
Time shift
Timeshift function allows you to watch a programme in time shifted mode.
Press the TImEshIfT button in viewing mode. Then you can use the tu buttons to move the
cursor to the desired time which you want to watch, afterwards press oK to confirm. In case
the info banner is not shown you just need to press the Info button to call it up/show again.
Time shift and Record
To perform this action you have to press the ● button after you started the Time Shift. Then
a confirmation window appears where you need to select Yes for buffering Time Shift and
record the present program. If you select No then it will only record the program.
TS/PS
ON/ OFF, defines the standby mode after recording
ON/ OFF, defines if an interrupted recording should be recovered
(e.g. power breakdown
13