Connection; Default Pin-Code: 0000; Your Receiver; Remote Control - Strong SRT 56 User Manual

PART 1 • English

2.0 ConnECTIon

Connecting to Tv, Terrestrial Antenna, IR Eye and main Power
To receive the broadcast signal, the terrestrial antenna cable should be connected to
the ANT IN connector at the receiver. Then connect the IR connector into the receiver
and make sure it is properly connected to the IR sensor input. Afterwards you can plug
the power adapter to the main power source (100 ~ 240 V, 50/60 Hz Auto detecting).
After all connections are established carefully, the IR eye LED must light, otherwise the
Remote Control will not react.
Connection to a usb device
Connecting to DvD Recorder
Connecting to a Projector

2.1 Default Pin-Code: 0000

3.0 YouR RECEIvER

1. sCART PoRT
2. mini usb-Port
3. AnT In
4. To Tv
5. IR sensor slot
6. DC In

3.1 Remote Control

1.
2. 0~9
3.
4. RECAll
5. PAgE+/PAgE-
6. vol+/vol-
7. Ch+/Ch-
8. oK
9. mEnu
10. EXIT
11. Info
12. sub
To connect to your TV set.
To connect your included converter USB cable and then your USB
storage device
To connect an antenna for reception of broadcasting signal
(support antenna power 5 V DC).
To connect to the areal input of your TV or to a second receiver.
To connect IR eye plug
To connect the power adapter plug (5 V DC/2 A).
Turns the receiver On/Standby
Channel selection or value input
Mutes audio output of the receiver
Back to previous shown channel
Page up/down
TV mode: Volume up/down; Menu mode: navigation & change settings
TV mode: Channel up/down; Menu mode: navigation
TV mode: Displays the current channel list;
Menu mode: Activates the highlighted menu item.
TV mode: Opens the main menu. Menu mode: You will get one step
back. Multimedia: Go to upper folder
Exits from the menu or sub-menu
Shows the actual channel information
Shows list of subtitle languages
Fig. 1
Fig 2
Fig 3
Fig 4
Fig. 5
Fig. 6
5