Enjoying The Fm/Am Radio; Adjusting The Subwoofer Level; Using Subwoofer Boost; Adjusting The Speaker Level - Panasonic SC-PT760 Operating Instructions Manual

Enjoying the FM/AM radio
It)
o
o
g
a::
SELECTOR
vTUNE ......
• To select a 2-digit number ( , - ,
I I -, (
e.g. 12:
[~10] ~
[1]
~
[2] )
L
ri , [ )
Alternatively. press [v. 1\],
L - - - - '
and then press [OK].
Main unit:
CD
While listening to the radio broadcast
Press [MEMORY] twice.
®
While a channel no. is flashing on the display
Press [v TUNE 1\], and then press [MEMORY].
A station previously stored is overwritten when another station is
stored in the same channel preset.
Select
"FM',or"AM".------
• Main unit:
Press [SELECTOR].
Select
the
frequency.--------..-.
• Main unit:
Press [-TUNE MODE] to select
"MANUAL" on the display, and then press
[v TUNE 1\ lto select the frequency.
• To start automatic tuning, press and hold
J [ .......
~~]
(main unit: [v TUNE 1\]) until
.,,J
the frequency starts scrolling. Tuning
i~,~
__
~tO£!.s .~~n_ a st~on is fou~d .
• Presetting stations manually
Up to 30 stations can be set in each band. FM and AM.
CD
While listening to the radio broadcast
Press [OK].
®
While the frequency is flashing on the display
Press the numbered buttons to select a channel.
·TUNEMODE
Manual tuning
FM frequency step
Main unit only
The step is factory-set to 0.2-MHz, but you can change it to receive
broadcasts allocated in O.1-MHz steps.
CD
Press [SELECTOR] to select "FM".
®
Press and hold [SELECTOR].
After a few seconds the display changes to show the current minimum
frequency. Continue to hold the button down. The minimum frequency
changes and the step is changed.
To return to the original step, repeat steps
CD
and
®.
..
After changing the setting. previously preset frequencies will be cleared.
Preset them again.
EXIT: SETUP
~SET
~.RETURN
SUB W 1~SUB W 2~SUB W 3
t
I
BST6N~'BSfoFF'
.....
The SW BOOST indicator lights when
Subwoofer Boost is turned on.
Test tone will be output to each channel in the
following order.
LEFT, CENTER, RIGHT,
SURROUND RIGHT, SURROUND LEFT
2 . . .
· ,1.".:.¥~·.:·
. . . ' " ".
r
,;~.,~ ~"':':"
•."?'.'.\
Adjustthe'speakerlevel for each
: f :
OK
~t:~."'~~i
speaker. (CENTER, SURROUND
.,i·o. .
j;:>;:,~
RIGHT, SURROUND LEFT)
.
.,~
</',.
0,,:; -6
dB to +6 dB
,'y; •
To exit the screen, press [SETUP].
Using Subwoofer Boost
Adjusting the speaker level
~
-_.
• To check the current setting. press [SUBWOOFER LEVEL].
• The setting you make is retained. and recalled every time you play the
same type of source.
You can adjust the surround sound levels.
Preparation
• Press [+, - VOL] to adjust the volume to normal listening level.
• Select "TEST TONE" from "SPEAKER SETTINGS" in "AUDIO" menu
(~23).
Main unit only
You can enhance the subwoofer effect with strong bass.
Adjusting the subwoofer level
You can adjust the amount of bass. The unit automatically selects the
most suitable setting according to the type of playback source.
• To
adjust speaker level during play
(Effective when playing 5.1-channel sound or when Dolby Pro
Logic II is on.)
CD
Press and hold [-eH SELECT] to select the speaker.
While the speaker channel is displayed, press [-eH SELECT].
L ->C ->R ->RS ->LS ->SW
t I
• You can adjust SW (Subwoofer) only if the disc includes a
subwoofer channel and "eCPUI" is not lit.
®
Press [A] (increase) or [T] (decrease) to adjust the speaker
level for each speaker.
C, RS, LS, SW: -6 dB to +6 dB
(L, R: Only the balance is adjustable.)
To adjust the balance of the front speakers, while
"t.:'
or "R" is selected,
press [ ... ,
~J,