Questions And Answers; Authorisation - Siemens Gigaset C610H User Giude

Questions and answers

If you have any queries about the use of your
telephone, visit our website at
www.gigaset.com/service
for assistance 24/7.
The table below contains a list of common
problems and possible solutions.
The display is blank.
¥
1. The handset is not switched on.
Press and hold the end call key a.
¥
2. The battery is empty.
¢
Charge the battery or replace it
( page 9).
Not all menu options are displayed.
¥
The menu display is reduced (Standard mode).
•
Activate extended menu display
.
(Expert mode ) (
No Base
flashes on the display.
¥
1. The handset is outside the range of the base.
Move the handset closer to the base.
2. The range of the base is reduced because Eco
¥
mode is activated.
Deactivate Eco mode (
reduce the distance between the handset
and the base.
¥
3. The base is not switched on.
Check the power adapter of the base.
Please register handset
Handset has not been registered with the base or
¥
has been deregistered.
Register the handset (
Handset does not ring.
¥
1. The ringtone is deactivated.
Activate the ringtone (
¥
2. Call divert set for "All Calls".
Deactivate call divert (refer to base user
guide).
3. The telephone only rings when the phone
number is transmitted. ¥
¢
Switch on the ringtone for anonymous
calls ( page 41).
The other party cannot hear you.
You have pressed the mute key h. The handset
¥
is "muted".
Reactivate the microphone (
¢
page 24).
¢
page 36) or
flashes on the display.
¢
page 13).
¢
page 41).
¢
page 27).
Service (Customer Care)
You hear an error tone when keying an input (a
descending tone sequence).
¥ Action has failed/invalid input.
Repeat the operation.
Watch the display and refer to the user guide
if necessary.
Exclusion of liability
Some displays may contain pixels
(picture elements), which remain acti-
vated or deactivated. As a pixel is made
up of three sub-pixels (red, green, blue),
it is possible that pixel colours may vary.
This is completely normal and does not
indicate an error.

Authorisation

This device is intended for use within the
European Economic Area and Switzerland. If
used in other countries, it must first be
approved nationally in the country in ques-
tion.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the essential
requirements and other relevant regulations
laid down in Directive 1999/5/EC.
A copy of the 1999/5/EC Declaration of
Conformity is available at this Internet
address:
www.gigaset.com/docs.
45