Questions And Answers; Approval - Siemens E49H User Manual

Questions and answers

If you have any questions about the use of
your phone, visit us at any time at
www.gigaset.com/customercare.
The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
2. The batteries are flat.
¥
Charge or replace the batteries
¢
( page 7).
"Base x" flashes on the display.
1. The handset is outside the range of the base
station.
¥
Move the handset closer to the base sta-
tion.
The base station's range is reduced because
eco mode is activated.
¥
Deactivate eco mode (
reduce the distance between the hand-
set and the base station.
2. The base station is not switched on.
¥
Check the base station mains adapter.
Please register flashes on the display.
Handset has not been registered with the base
station or has been deregistered.
¥
Register the handset (
Handset does not ring.
The ringer is deactivated.
¥
Activate the ringer (
The other caller cannot hear you.
You have pressed the
set is "muted".
¥
Activate the microphone again
¢
( page 19).
You hear an error tone when keying an input
(a descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user
guide if necessary.
32
a
.
¢
page 25) or
¢
page 9).
¢
page 29).
u
(INT) key. The hand-

Approval

This device is intended for use within the
European Economic Area and Switzerland.
If used in other countries, it must first be
approved nationally in the country in
question.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the
essential requirements and other relevant
regulations laid down in Directive 1999/5/
EC.
A copy of the 1999/5/EC Declaration of
Conformity is available at this Internet
address:
www.gigaset.com/docs.