Specifications; Contact With Liquid; Questions And Answers - Siemens Gigaset A165 Manual

Appendix
Entering special characters
Standard characters
1x 2x
1
1
Space
Q
. ,
P
* /
#
Abc--> 123-->
123 abc

Specifications

Recommended battery pack
(Valid at the time of going to press)
Nickel-metal-hydride (NiMH):
Handset A16: V30145-K1310-X383
Handset A26: V30145-K1310-X359, X402
The handset is supplied with the recommended
battery pack.
Base station power consumption
In standby mode: approx. 2W
During a call: approx. 3W
General specifications
DECT standard
GAP standard
Range
Base station power supply 230 V ~/50 Hz
Environmental conditions
in operation
3x 4x 5x 6x
£ $ ¥
? ! 0
( ) <
# @ \
is supported
is supported
up to 300 m outdoors,
up to 50 m in buildings
+5 °C to +45 °C;
20% to 75% humidity
9
Care
Wipe the base station, charging cradle and handset
with a damp cloth (do not use solvent) or an anti-
static cloth.
Never use a dry cloth. This can cause static.
¤

Contact with liquid

+
=
If the handset has come into contact with liquid:
1 Switch off the handset and remove the bat-
&
tery pack immediately.
2 Allow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place for at least
72 hours (not in a microwave, oven etc.).
4 Do not switch on the handset again until it is
completely dry.
When it has fully dried out, you will normally be
able to use it again.

Questions and answers

If you have any queries about the use of
your phone, you can contact us any time at
www.gigaset.com/customercare.
The table below contains a list of common
problems and possible solutions.
Problem
Nothing
appears in the
display.
No reaction to
keystroke.
No wireless
connection to
the base sta-
tion, Base
flashes in the
display.
!
Cause Solution
The handset is not Press the end call key
a
switched on. for approx. 5 sec.
or place the handset
in the base station.
Charge/replace the
Battery pack is battery pack (page 3).
flat.
The key lock is Press the hash key
activated. for approx. 2 sec.
(page 1).
The handset is Move the handset
outside the range closer to the base
of the base sta- station.
tion.
The handset is not Register the handset
registered. (page 3).
The base station is Check the power
not switched on. connector at the base
station (page 2).
Cords not routed Check cord routing
correctly (page 2).
R