Auditing Accounts; Using The Rspf - Sharp AR-505 Operation Manual

AUDITING ACCOUNTS

If this copier has been programmed in the auditing mode, it will not
function until an assigned 5-digit account number has been entered.
KEY OPERATOR See page 8-9 for setting the auditing mode.
1 2 3
4 5
6
7
8 9
AUDIT CLEAR
PROGRAM
0
P
2-2
The initial status of the message display will be:
ENTER YOUR ACCOUNT NUMBER. –––––
INTERRUPT
Enter your account number using the 10-key pad.
As each digit is entered, the dashes in the display will change to
asterisks.
The following message will appear after the number is entered.
CLEAR
ACCOUNT STATUS: COPIES MADE 000,000
C
"COPIES REMAINING" will appear only if account limit has been
set using a key operator program.
KEY OPERATOR
The message will be displayed for several seconds, then change
to the following message.
READY TO COPY.
When a copy run is performed, the following message will
appear.
READY TO COPY.
PRESS [AUDIT CLEAR] WHEN FINISHED.
In the interrupt copy mode (see page 2-20), the following
message will appear instead of the message above.
READY TO COPY. WHEN COPYING IS
FINISHED, PRESS [INTERRUPT].
NOTE:
If an unassigned number is entered, the message display will show
"ENTER YOUR ACCOUNT NUMBER.-----", indicating that the
number was not accepted.
When the key operator program of account number security has
been set:
If an unassigned number is entered three successive times, the
copier will not accept another number for one minute, and the
following message will appear.
PLEASE SEE YOUR KEY OPERATOR FOR
ASSISTANCE.
KEY OPERATOR
security.

USING THE RSPF

COPIES REMAINING 000,000
See page 8-14 for account limit settings.
See page 8-15 for account number