Auditing Accounts - Sharp AR-5015 N Operation Manual

AUDITING ACCOUNTS

If this copier has been programmed in the auditing mode, it will not function
until an assigned 3-digit account number has been entered. See page 39 for
setting the auditing mode.
If the copier has been programmed in the auditing mode, "–––" will appear
in the copy quantity display in the initial conditions.
Enter your account number using the numeric keys.
1
G
As each digit is entered, the dashes in the copy quantity display will
disappear.
G
After the number is entered, the copy quantity display will change
to 0.
G
If an unassigned number is entered, "––– " will appear again in the
copy quantity display, indicating that the number was not accepted.
When copying is completed, press the AUDIT CLEAR
2
( ) key.
G
"––– " will appear again in the copy quantity display, indicating the
auditing mode.
G
In the interrupt copy mode (see page 25), press the INTERRUPT (
key after an interrupt copy run is completed. All previous copier
settings will be restored and the previous account number will be
active.
)
13