Table of Contents
Advertisement
READY TO COPY.
CANCEL
ERASE
EDGE ERASE
CENTRE ERASE
EDGE+CENTRE
ERASE
CANCEL
ERASE
EDGE ERASE
CENTRE ERASE
EDGE+CENTRE
ERASE
OK
CANCEL
OK
(0~1)
1
inch
INTERRUPT
CLEAR ALL
CA
START
CLEAR
C
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
AUTO
AUTO A4
EXPOSURE
PAPER SELECT
4
Select the desired erase mode.
Select "EDGE ERASE", "CENTRE ERASE" or "EDGE+CENTRE
OK
ERASE" on the touch panel. The selected erase mode will be
OK
highlighted.
(0~1)
1
inch
Adjust the amount of edge erase and/or centre erase if
5
OK
needed.
OK
The amount can be adjusted between 0mm and 20mm in 1mm
increments (0" and 1" in 1/8" increments).
(0~20)
10
mm
Press the upper "OK" key on the touch panel.
6
Make all other desired copier selections and press the
7
START (
If the document feeder is used, scanning of originals and copying
will start.
If the document glass is used in the SORT mode, proceed to the
next step.
Replace the finished original with the next original after
8
the START (
the START (
READ-END
have been scanned. Then, press the "READ-END" key
on the touch panel.
100%
Copying will start at this time.
COPY RATIO
Up to 120 sheets of A4 (8-1/2" x 11") originals or up to 60 sheets
of originals larger than A4 (8-1/2" x 11") can be scanned.
To cancel the ERASE function, select the ERASE function again
and press the "CANCEL" key.
) key.
) key indicator lights up, and then press
) key. Repeat this step until all originals
ERASE
3-7
Advertisement
Table of Contents
Troubleshooting
