Adding Toner - Sharp AR-505 Operation Manual

ADDING TONER

The message "(TONER SUPPLY IS LOW. PRESS
GUIDANCE.)" will appear in the message display before the toner
supply is completely empty. If copying is continued, copies will
gradually become lighter until the copier stops and the message
display changes to "ADD TONER. PRESS
indicating that the toner supply is empty. Toner can be added any time
after the message "(TONER SUPPLY IS LOW. PRESS
GUIDANCE.)" appears. To add toner, stop the copier and proceed as
below. When either message appears, you can use the INFORMATION
( ) key for detailed information as necessary.
During long copy runs of multiple originals containing many images
and/or dark shades, "TONER REPLENISHMENT IN PROGRESS." will
appear and the copier will stop making copies even though toner is left.
The copier will automatically cycle and replenish the toner to the
normal level and then the START (
the START ( ) key to resume copying.
5X 20X
FOR GUIDANCE."
) key indicator will light up. Press
Open the front cover.
1
Pull down the toner hopper lock lever and pull the toner
2
hopper out slowly until it stops.
Tap on the top of the toner cartridge 5 times. Hold the
3
20X
new toner cartridge vertically and vigorously shake it
up and down about 20 times, then invert the cartridge
and again shake it up and down about 20 times. This will
loosen the toner and allow it to flow more easily into the
toner hopper.
For best copying results, be sure to use
FOR
only Sharp products. The package of
Sharp toner has the Genuine Supplies
label.
FOR
GENUINE SUPPLIES
4-5