Set The Jumpers; Jumper Jp6: Clear Cmos Memory - MATSONIC MS6383E Manual


! 

   

Set the Jumpers

Jumpers are sets of pins which can be connected together with
jumper caps. The jumper caps change the way the mainboard
operates by changing the electronic circuits on the mainboard. If a
jumper cap connects two pins, we say the pins are SHORT. If a
jumper cap is removed from two pins, the pins are OPEN.
JP11 JP25
1
JP17
1
JP20
JP6

Jumper JP6: Clear CMOS Memory

Use this jumper to clear the contents of the CMOS memory. You
may need to clear the CMOS memory if the settings in the setup
utility are incorrect and prevent your mainboard from operating. To
clear the CMOS memory, disconnect all the power cables from the
mainboard and then move the jumper cap into the CLEAR setting
for a few seconds.
Function
Normal Operation
Clear CMOS memory
Note: The mainboard ships with this jumper in the CLEAR
position so you must change this jumper to NORMAL.
12
1
Jumper Setting
Short Pins 1-2
Short Pins 2-3