Jumper Settings; Jumpers - MATSONIC MS-5120 Manual

MS5120 Mainboard Manual

Jumper Settings

Jumpers

You can configure hardware options by setting jumpers on the
motherboard. See figure 2-1 for jumper location. Some jumpers on the
board have three metal pins with each pin representing a different function.
To set a jumper, a black, white, or red cap containing metal contacts is
placed over the jumper pin(s) according to the required configuration. A
jumper is ÒshortedÓ when a cap has been placed on one or two of its pins.
NOTE : Users are not encouraged to change the jumper settings that are
not listed in this manual. Changing the jumper settings
improperly may adversely affect system performance.
Pins 2 and 3 are shorted with a jumper cap
P3 P2 P1
Pins 1 and 2 are shorted with a jumper cap
P3 P2 P1
The jumper is open
The jumper is shorted (closed)
10