Storing Caller List
Information in the Direct
Dial memory
You can store numbers in the Caller List
to the Direct Dial memory ({ M1 }, { M2 }
and { M3 }).
Make sure that the handset is on the
cradle, the AC adaptor is connected
and the Speakerphone/headset {s/W}
indicator light is off.
1
Press {
} or {
4
Caller List.
2
Scroll to the caller you want to
store in the Direct Dial memory
by pressing {
?
}
{
3
Press
• If the number requires editing, see
page 27.
123456789
4
Press { OK } (Next key).
a) If a name is not required,
press { OK } (Next key).
b) If a name is required, enter the
name (p. 32). When finished,
press { OK } (Next key).
Enter name
JACK SMITH
>Save phonebook
Save M1,M2,M3
} to enter the
3
} or {
4
3
}.
.
[OK]=Next
[OK]= Next
[OK]=Save
5
Press {
4
}.
Save phonebook
>Save M1,M2,M3
6
Press one of the Direct Dial
button ({ M1 }, { M2 } or { M3 })
(Save key).
(Example: { M1 } is pressed.)
If the Direct Dial button
selected is occupied, the
display will be shown as
below.
M1 is occupied
Overwrite ?
[
To overwrite, press { OK }
(Yes key).
To select the other empty Direct
Dial memory, press {
and press an empty Direct Dial
button ({ M1 }, { M2 } or { M3 }).
• A long beep sounds.
• The display will return to Caller List.
You can continue storing other
items. To exit the programming
mode, press
seconds.
• To erase other stored items from the
Direct Dial memory see page 37.
• To cancel during programming, press
{ ? }
. Start again from step 1.
• You cannot store caller information in the
Direct Dial memory if a phone number is
not displayed.
Caller ID Service
M1,M2,M3=Save
]=No
[OK]=Yes
3
} (No key)
{ ? }
or wait for 60
29