Turning The Power Off - MIMAKI JV5-160S Operation Manual

Turning the power off

After completing all desired operations with the printer, press the power switch on the front of the printer to
turn the power off.
Before turning the power off, make sure that the printer is not receiving any data from the computer and that
the printer has no data that has not been output yet.
Also make sure that the heads are located at the capping station.
Do not turn off the main power switch on the rear face. The power is turned on
periodically and the nozzle clogging preventive function is activated. (Flushing
function)
If the main power switch is left turned off for an extended period of time, noz-
zles will be clogged. In such a case, the printer must be repaired by MIMAKI's
service engineer.
Keep the front cover and maintenance covers all closed. If any of the covers is
open, the nozzle clogging preventive function will not be activated.
At turning off the power switch, the exhaust fan of the printer also stops. For
ventilation, do not turn off the power switch immediately after printing.
If the power to the printer was turned off without the heads capped, turn the
power on again. The heads will return to the capping station, where they will be
capped and prevented from drying.
If the power is turned off while the printer is engaged in printing, the heads may
fail to be retracted in the capping station. If the heads are left without capped
for an extended period of time, nozzles may be clogged.
Even when the main power switch is put off for moving the equipment, make
sure to press the power switch on the front of the equipment and confirm that
the power is off and then put off the main power switch.
STEPS:
1
Press the power switch on the front.
The lamp of the power switch goes out.

Turning the power off

3-51