Cleaning Interval While In Stand-By Mode [Cleaning] - MIMAKI JV5-160S Operation Manual

Cleaning interval while in stand-by mode [CLEANING]

This function is to be executed instead of TUBE WASH after the cleaning solution has been used up.
Set the cleaning type and the intervals at which cleaning operation is to be performed.
This function does not operate when the error message relating to ink, such as
INK NEAR END or INK END, is displayed.
While this function is being executed, the display indicates the progress of
cleaning and no key operation is available. (Refer to "If the printed pattern is
abnormal (Cleaning) (p.3-29)" )
This function operates only when the printer is left with the display as shown
below:
L. ∗ >
STEPS:
1
Make sure that the printer is in LOCAL mode, and then select [MAINTENANCE] using
the [FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
L. ∗ >
2
Select [ROUTINE SETUP] by pressing the [ ] key six times and press the [ENTER]
key.
MAINTENANCE
ST.MAINTENANCE
3
Select [CLEANING] by pressing the [ ] key three times and press the [ENTER] key.
Setting periodical operations in stand-by mode [ROUTINE SETUP]
[JV5-01]
width : ∗∗∗∗ mm
[JV5-01]
width : ∗∗∗∗ mm
6
times
<ent>
3
times
R. ∗ >
[JV5-01]
∗∗.∗∗ m
FUNCTION
MAINTENANCE <ENT>
MAINTENANCE
ROUTINE SETUP <ent>
Clean.worksAtTheTime
of the WashLiquidEND
ROUTINE SETUP
CLEANING <ent>
4-37