Tube Cleaning Interval While In Stand-By Mode [Tube Wash] - MIMAKI JV5-160S Operation Manual

4 Daily Maintenance

Tube cleaning interval while in stand-by mode [TUBE WASH]

There may be a chance that ink tubes can be clogged with coagulated ink.
To avoid clogging, clean the ink tubes at regular intervals.
STEPS:
1
Make sure that the printer is in LOCAL mode, and then select [MAINTENANCE] using
the [FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
2
Select [ROUTINE SETUP] by pressing the [ ] key six times and press the [ENTER]
key.
3
Select [TUBE WASH] by pressing the [ ] key twice and press the [ENTER] key.
4
Input the interval at which cleaning operation is to be performed periodically, using
the [ ] or [ ] key.
Input range: OFF, 1 to 168
Register the setting by pressing the [ENTER] key.
The following display will appear if supply of cleaning liquid is required.
5
Press the [END] key several times.
The printer returns to LOCAL mode.
4-36
L. ∗ >
[JV5-01]
width : ∗∗∗∗ mm
MAINTENANCE
ST.MAINTENANCE <ent>
6
times
Twice
ROUTINE SETUP
WASH INTERVAL = 1h
∗∗ Washing liquid ∗∗
L. ∗ >
[JV5-01]
width : ∗∗∗∗ mm
FUNCTION
MAINTENANCE <ENT>
MAINTENANCE
ROUTINE SETUP <ent>
WashingIntervalInThe
stand by is set up.
ROUTINE SETUP
TUBE WASH <ent>