If Error 202 [Device Construction] Is Displayed; Checking Detailed Results Of Checks - MIMAKI JV5-160S Operation Manual

If ERROR 202 [DEVICE CONSTRUCTION] is displayed

This printer checks its configuration every time it starts.
The configuration checking function checks the resource configuration necessary for use of this printer.
When there is an error in any element of the printer, the printer can be started by disconnecting the faulty
element.
1 HDC check
2 Head connection check
3 Head memory check
4 SDRAM check
If the results of the checks 1 to 4 above show that any error has occurred, the display shows the configura-
tion error (ERROR 202), and the printer discontinues starting.
By pressing the [ENTER] key with the configuration error displayed, you can check the detailed results of
the checks and restart the printer with a limited resource configuration.
Checking the detailed results of the checks
If the checks 1 to 3 shows any error, an element developing an error is marked with " X ", while a question-
able element is marked with " ? ". The check 4 result shows the available size of SDRAM.
RESULTof DIAGNOSIS
HDC : 123x
HEAD-MEM : 12x4
SDRAM : 0.5GB (1GB)
Confirming the starting with a limited configuration
The available configuration is displayed. Pressing the [ENTER] key will restart the printer.
If there is any error detected by the checks 1 to 3, limited heads are available.
If an error has been detected by the check 4, the error (ERROR 203) is displayed at transition from
LOCAL mode to REMOTE mode and at start of printing.
The settings of an limited configuration are not stored in memory, and thus the printer checks its configura-
tion every time it starts.
When the printer has been started with a limited configuration, you can check the detailed results of the
checks using the guidance function.
If the display shows the message [ERROR203 SDRAM SIZE], turn off the power
to the printer and turn it on after a while. If the same error message appears
again, contact your local distributor to call for service.
(When there is available SDRAM mounted, the printer can be started without
expanding SDRAM. However, printing speed may drop depending on the reso-
lution.)
Checks for any error in the HDC.
Checks for any error in connection of any of Head 1 to 4.
Checks for any error in access to head memory.
Checks for any error in SDRAM.
∗ ∗ ∗ ∗ ERROR 202 ∗ ∗ ∗ ∗
DEVICE CONSTRUCTION
Wrong Point Was Found To
The Composition.
HEAD : 12x?
:ent
HEAD12 . . is Not-USE!
Possible composition
HEAD . . 34 OK ? :ent
Ink cartridge trouble
5-13