Cleaning The Heads And Their Surrounding Parts - MIMAKI JV5-160S Operation Manual

Cleaning the heads and their surrounding parts

[CR.MAINTENANCE]
Take great care, especially during cleaning, not to damage the heads, which employ very precise mechanisms.
Using a cotton swab, rub off the gelatinous ink that may be adhering to the lower part of the slider and sur-
rounding parts of the heads. In doing so, never rub the nozzle part of the heads.
Be sure to wear the supplied goggle and gloves.The ink contains an organic
solvent. If ink settles on your skin or gets in your eyes, immediately and com-
pletely wash them off with water. Then, consult a doctor as soon as possible.
(When solvent ink is used)
STEPS:
1
Make sure that the printer is in LOCAL mode, select [MAINTENANCE] using the
[FUNCTION] key, and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
L. ∗ >
2
Select [CR.MAINTENANCE] by pressing the [ ] key once and press the [ENTER] key.
MAINTENANCE
ST.MAINTENANCE
3
When [CARRIAGE OUT] is displayed, press the [ENTER] key.
The carriage moves to the left end of the printer body.
4
Open the left maintenance cover and the front cover.
[JV5-01]
width : ∗∗∗∗ mm
Once
<ent>
CR.MAINTENANCE
CARRIAGE OUT

Cleaning the heads and their surrounding parts

FUNCTION
MAINTENANCE
MAINTENANCE
CR.MAINTENANCE
: ent
<ENT>
<ent>
4-27