Konica Minolta BIZHUB C352P User Manual page 109

Setting up the printer driver
6
To apply the settings, restart this machine (turn it off, then on again).
– When the machine is turned off, then on again, wait at least 10 sec-
onds to turn the machine on after turning it off. The machine may
not operate correctly if it is turned on immediately after being turned
off.
Turn this machine back on to apply the IP address.
Note
The network settings should be specified according to instructions from
the network administrator.
A password is required in order to enter Administrator mode. Contact the
administrator for the administrator password.
!
Detail
Although the IP address is entered without using the DHCP server in the
procedure described here, it is also possible that the IP address
automatically be assigned by the DHCP server. When "IP Address" is set
to "Auto Input" and "DHCP Setting" is set to "ON", the IP address, subnet
mask and default gateway are automatically assigned by the DHCP
server on the network, so it is not necessary to assign them manually.
However, consider the following when setting "DHCP Setting" to "ON".
Consult with the network administrator to check that a DHCP server
exists. If a DHCP server does not exist, be sure to specify settings for "IP
Address", "Subnet Mask" and "Default Gateway".
If the IP address and other settings have been assigned by the DHCP
server, they may automatically be changed. If the IP address and other
settings are changed and a printer on the network has been specified by
its IP address for printing, printing may not be possible since this ma-
chine cannot communicate with the network.
If "DHCP Setting" has been set to "ON", it is recommended that a fixed
IP address be assigned to this machine in the DCHP server settings.
C352P (Phase 3)
3
3-37