Konica Minolta BIZHUB C250P User Manual page 101

Setting up the printer driver
6
To apply the settings, restart this machine (turn it off, then on again).
Turn this machine back on to apply the IP address.
Note
The network settings should be specified according to instructions from
the network administrator.
A password is required in order to enter Administrator mode. Contact the
administrator for the administrator password.
!
Detail
Although the IP address is entered without using the DHCP server in the
procedure described here, it is also possible to automatically assign the
IP address from the DHCP server. When "DHCP Setting" is set to "Ena-
ble", the IP address, subnet mask, and gateway address settings are au-
tomatically assigned from the DHCP server on the network, so it is not
necessary to assign them manually. However, note the following when
setting "DHCP Setting" to "Enable".
Check with the network administrator that the DHCP server exists. If the
DHCP server does not exist, be sure to specify settings for "IP Address",
"Subnet Mask", and "Default Gateway".
If the settings for the IP address and other items have been assigned us-
ing the DHCP server, there is a possibility that they may be automatically
changed. When the settings for the IP address and other items are
changed, if the IP address has been used to specify a printer on the net-
work for printing, there is a possibility that printing may not be possible
because this machine cannot communicate with the network.
If "DHCP Setting" has been set to "Enable", it is recommended that the
IP address assigned to this machine be fixed in the DHCP server settings.
When turning the machine off, then on again, wait at least 10 seconds to
turn the machine on after turning it off. The machine may not operate cor-
rectly if it is turned on immediately after being turned off.
C250P
2
2-35