Advertisement
For power supply, do not connect in series much more than 20 units, use
another mains supply for next 20 units.
2. Technical Specification
It can be operated by DMX512 control or can be used as an individual unit without
controller.
Please use a 3 pin XLR cable/plug when link in master/slave mode.
Smooth 0-100% dimming, and variable strobe speed.
5 Channels
Channel 1 = Pan
Channel 2 = Barrel
Channel 3 = Strobe
Channel 4 = Color
Channel 5 = Dimmer
Voltage: AC 100-240V~50/60Hz
Fuse: T 2A
LED: 1 x 10W LED
Power Consumption: 23W
Dimension: 311 x 135 x 170 mm
Weight: 3.4kg
3. Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit
is firmly fixed to avoid vibration and slipping while operating. Always ensure that the
structure to which you are attaching the unit is secure and is able to support a weight of 10
times of the unit's weight. Also always use a safety cable that can hold 12 times of the
weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out
of the touch of people and has no one pass by or under it.
4-
4. How To Control The Unit
4.1 Control Panel
○
1 Dip switches：For different function setting.
○
2 Only for remote control: Connecting with CA-8/CA-9/CA-9RTX to control the unit for
Stand by, Function and Mode function.
○
3 DMX output: For DMX512 link, use 3/5-pin XLR plug cable to link the next unit.
○
4 DMX input: For DMX512 link, use 3/5-pin XLR plug cable to input DMX signal.
○
5 Power：Connect to supply mains power.
○
6 Microphone: Receives the sound to control the unit
4.2 Master/Slave Operation
The unit can be linked together in daisy chain as many as you need in master/slave mode
to perform the great built-in pre-programmed lighting shows triggered by music.
In Master/Slave mode refer to the DMX settings below:
Master unit: DMX start address MUST be set to 001. (First DIP switch = ON, all others
are OFF)
Slave units: DMX start address may have any value but NOT 001 (example: set the first 3
DIP switches to ON)
2-Light Show
Dipswitch 10 "off" means the unit works normally and "on" means 2-Light show. In order to
create a great light show, you can set dip switch 10 "on" on any unit that is linking to the
master unit to get contrast movement to the master unit, even if you have two units only.
Dipswitch 10 on the first (Master) unit is no use for the 2-light show as it is the master unit
that operates the light show.
5-
Advertisement
