Malfunction Causes And Remedies - Silvercrest KH 2382 Operating Instructions Manual

Troubleshooting

Malfunction causes and remedies

The following table will help with localizing and remedying minor malfunctions:
Defect
The device will not
switch on
No sound
The CD will not load
or eject
Function buttons are
not functioning
The CD jumps
Failure with burnt CDs
MP3/CD Car Radio KH 2382
Possible cause
The ignition is not
switched on
The fuse is defective.
The volume is set to
minimum.
The cables are not
connected correctly.
The sound is switched
off .
A CD is already inserted
into the device.
The CD has been inserted
the wrong way up.
The CD is dirty or
defective.
The temperature in the
vehicle is too high.
Condensation on the
laser lens
There is a malfunction
with the device.
The face plate is not
correctly installed.
The mounting angle
exceeds 30°.
The CD is very dirty or
defective.
Solution
Switch the ignition on by turning the
key.
Replace the fuse.
Increase the volume.
Check the cable connections.
Press the MU button to switch the
sound back on.
Remove the CD.
Insert the CD with the inscripted side
up.
Clean the CD or insert a diff erent CD.
Allow the vehicle to air out until the
temperature has again dropped to the
operational temperature.
Switch the device off for a few hours
and then try it again.
Press the RESET button.
Check to see that the face plate is
installed correctly.
Correct the mounting angle.
Clean the CD or insert a diff erent CD.
Check the burnt CD in another
playback device.
GB
33