Wall Thermostat; Remote Control - HAMPTON BAY H35-LP1 Owners & Installation Manual

INSTALLATION
PROPANE
For
*For installation of the DC Spark Box refer to the LP Conversion instructions in this manual.

WALL THERMOSTAT

A wall thermostat may be installed if desired.
Connect the wires as per the wiring diagrams.
Note that the wires are connected to the "TH"
on the gas valve. Use table below to determine
the maximum wire length:
Note: Preferable if the thermostat is installed
on an interior wall.
®
Hampton offers an optional programmable
thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or
UL approved may be used.
38
Units and Units Equipped with DC Spark Boxes*
CAUTION
Do not connect the millivolt
wall thermostat wires
to the 120V wires.
Thermostat Wire Table
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
Wire Size
14 GA.
16 GA.
18 GA.
20 GA.
22 GA.

REMOTE CONTROL

Use the Hampton
for this unit. Use of other systems may void
your warranty.
Max. Length
50 Ft. The remote control kit comes with a hand held
transmitter, a receiver and a wall mounting
32 Ft.
plate.
20 Ft.
12 Ft.
9 Ft.
®
Hampton H35 Direct Vent Freestanding Gas Stove
® Remote Control Kit approved