Table of Contents
Advertisement
installation
G)02-48
Side View
Bracket
The bottom right edge of Log G)02-48 must sit
snugly against the bracket. (Front Log 02-45 has
been removed so that the bracket can be seen.)
13) Test fire to ensure proper light off (make sure
flame flows smoothly from one end of burner
to the other. If there is any flame hesitation,
check that area for any blockage of the burner
port.
B)02-56
C)02-44
Wall Thermostat
A wall thermostat may be installed if desired. Con-
nect the wires as per the wiring diagrams.
Note: Preferable if the thermostat is installed
on an interior wall.
Hampton
®
offers an optional programmable thermo-
stat but any 250-750 millivolt rated non-anticipator
type thermostat that is CSA, ULC or UL approved
may be used.
CAUTION
Do not connect the millivolt
wall thermostat wires
to the 120V wires.
|
44
Hampton
H35E-11 Direct Vent Freestanding Gas Stove
®
Remote/IFC (Integrated Fireplace
Control) Coding/Pairing
To code the IFC to the hand held remote, follow the
procedure below.
1. Open the access panel of the unit.
NOTE: Ensure that the main ON/OFF switch is in
the ON position. (Unit will not function, unless
it is in ON position.
A)02-43
2. Plug in 120 volt power cord into a grounded
E)02-45
receptacle or install 4 AA batteries into battery
pack and plug into battery terminals located near
the gas valve. Do not use both. Only use the 4
AA batteries if 120 volt power is not present.
3. Press the black button on the lower left side panel
(when facing unit) until 3 beeps are heard.
4. Install 3 AAA batteries into the handheld remote.
5. Press the ON/OFF button on the handheld remote
within 10 seconds to code the remote to the IFC.
After 4 beeps are heard, handheld is paired with
IFC.
Access Panel
Reset
button
Manual Operation
(No Remote)
To divorce the remote transmitter, press the black
button on the lower left side panel (when facing unit)
until it beeps 3 times. Within 10 seconds press and
hold the black button again until a beep is heard.
After divorcing the remote transmitter, the ON/OFF
switch at the front of the unit will control the unit.
Final Check
Before leaving this unit with the customer, the
installer must ensure that the appliance is firing
correctly. This includes:
1) Clocking the appliance to ensure the correct
firing rate (rate noted on label) at 15 minutes.
2) If required, adjusting the primary air to ensure
that the flame does not carbon. First allow the
unit to burn for 15 min. to stabilize.
3) Check for proper draft.
CAUTION
Any alteration to the product that causes soot-
ing or carboning that results in damage to the
exterior facia is not the responsibility of the
manufacturer.
Advertisement
Table of Contents
