Optional Door Grill; Optional Wall Thermostat; Optional Remote Control Installation - HAMPTON BAY Hampton H25-NG Owners & Installation Manual

INSTALLATION
DECORATIVE DOOR
GRILL INSTALLATION
1) Turn the Grill Latches on the Rear of the
Door Grill as per the photo below.
Grill
Latch
Rear View of
Decorative Door Grill
2) Place the Door Grill into the Cast Front.
Secure the Door Grill by turning the Grill
Latches inward, between the glass and the
Cast Front.
Turn the Grill Latches inward to secure the
Door Grill.
30
OPTIONAL WALL
THERMOSTAT
A wall thermostat may be installed if desired.
Connect the wires as per the wiring diagrams.
Note that the wires are connected to the "TH"
on the gas valve. Use table below to determine
the maximum wire length:
Note: Preferable if the thermostat is in-
Grill
stalled on an interior wall.
Latch
Hampton offers an optional programmable ther-
mostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or
UL approved may be used.
Do not connect the millivolt
wall thermostat wires
to the 120V wires.
Thermostat Wire Table
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
Wire Size
14 GA.
16 GA.
18 GA.
20 GA.
22 GA.
CAUTION
Max. Length
50 Ft.
32 Ft.
20 Ft.
12 Ft.
9 Ft.
Hampton H25 Direct Vent Freestanding Gas Stove
OPTIONAL REMOTE
CONTROL
Use the Hampton Remote Control Kit approved
for this unit. Use of other systems may void your
warranty.
The remote control kit comes with a hand held
transmitter, a receiver and a wall mounting
plate.
1) Choose a convenient location on the wall to
install the receiver and the receptacle box
(protection from extreme heat is very impor-
tant). Run wires from the fireplace to that
location, use Thermostat Wire Table.
2) Connect the wires as per the wiring diagram
below.
CAUTION
Do not connect the
millivolt remote control wires
to the 120V wires.
3) Install 3 AAA alkaline batteries in transmit-
ter and 4 AA alkaline batteries in the
receiver. Install the receiver and its cover
in the wall. Switch the remote receiver to
"remote" mode. The remote control is now
ready for operation.