Palm PRE User Manual page 166

Palm pre phone
Hide thumbs Also See for PRE:
Table of Contents

Advertisement

10
Position the back cover over the phone and gently press the top two
clasps (a), located at the top corners. Then press the two clasps (b)
halfway down either side of the phone.
11
Slide out the keyboard (see
two clasps (c) at the bottom corners.
166
Chapter 11 : Troubleshooting
Slide out the
keyboard), and then press the
12
Press and hold the
power
your phone until you see a logo on the screen (approximately five
seconds). Please be patient while your phone starts up.
If your phone does not turn on after you insert the battery and press and hold
TIP
power, you need to connect your phone to the AC charger to charge it (see
Charge the
battery).
I inserted or removed the SIM card without taking out the
battery – now I can't connect to the network.
If you inserted or removed the SIM card before you removed the battery,
your phone cannot connect to the network. To restore the network
connection, do the following:
1
Remove the battery (see
I need to replace the
instructions).
2
Remove the SIM card.
3
Reinsert the SIM card.
4
Replace the battery and the back cover (see
battery, steps 6–8, for instructions).
5
Press and hold the
power
your phone until you see a logo on the screen (approximately five
seconds). Please be patient while your phone starts up.
6
If Aeroplane Mode appears in the top left-hand corner of the screen,
tap the top right-hand corner of the screen and tap
Aeroplane
Mode.
button on the top right-hand corner of
battery, steps 1–5, for
I need to replace the
button on the top right-hand corner of
Turn off

Advertisement

Table of Contents
loading

Table of Contents