2. Installation Instructions
For RS-232 Cards, there are two Installation steps to installing the Boost.PCIe driver:
•
1. CARD driver
2. PORT driver
For RS-422/485 Cards, there are three Installation steps to installing the Boost.PCIe driver:
•
1. CARD driver
2. PORT driver
3. BASE SYSTEM DEVICE driver. This is the RS-422/485 Controller
Each step will take you through a full installation using the Found New Hardware wizard.
•
Once the Card is installed, the Operating System will detect the COM Port. All you will need to do to
•
install the COM Port is to run through the same installation steps as the Card. This also applies to
the RS-422/485 Controller
Follow the Operating System specific instructions below to start the installation procedure.
•
If you have any issues with installation, please follow the steps in Section 4: Uninstallation, then attempt to
install again. If you still have issues, see Section 6: Troubleshooting and Testing
PX Range Product Manual
PLEASE READ CAREFULLY
Version 2.3 © Copyright Brainboxes Limited 2013
Page 6 of 45