Table of Contents
Advertisement
INSTALLATION "ELECTRICAL CONNECTION"
IMPORTANT : INFORMATION FOR QUALIFIED INSTALLERS.
The electric installation for the oven should comply with the norms in force in the country of
installation.
Connection to the network must be by mean of an earthed outlet equipped with a multi-pole
circuit-breaker having a distance between contacts of at least 3 mm.
The installation must be protected by suitable fuses, and have wires with a large enough
cross-section to take the load required by the oven.
The oven is fitted with a power level lead for connecting exclusively to a voltage of 230 V AC
across the phases or across phase and neutral.
Connection must be carried out in compliance with the diagram having first checked the supply
voltage indicated on the meter, the circuit breaker setting.
The Earth wire (green/yellow) must be connected to the earth of both power supply and appliance
terminals.
Do not forget that the oven may require after-sales service. To allow easy servicing, position the
electrical outlet so that the oven can be removed from its space while still connected.
Caution :
Check the continuity of the earth installation before connecting.
The manufacturer will not be liable for any incident or the possible consequences that may
arise from the use of the oven which has not been earthed, or connected to an earth with
defective continuity.
Power supply cable : if the power supply cable must be changed, please have this done by our
after-sales technicians or by a qualified engineer.
Oven isolation
switch
Connection
box
18
230-V AC Mains house meter
across Phases or
across Phase and Neutral
Consumer unit
Circuit breaker
minimum rating 25 Amp
Fuse 20 Amp
Earth
Appliance connection point
Advertisement
Table of Contents
