Chapter 4: Software Installation And Setup; Installing Oms And The Studio 4 Software - OPCODE STUDIO 4 Instruction

CHAPTER 4:
INSTALLING OMS AND THE
STUDIO 4 SOFTWARE
NOTE: If you have never used OMS, you
should stop and read the OMS manual
before continuing with the Studio 4
manual.
The Studio 4 uses the OMS Setup and
Studio Patches Editor applications with
the Studio 4 OMS driver to control all
mapping, channelizing routing and time-
code functions.
Follow the installation instructions on the
OMS disk to install OMS and the Studio 4
software.
What's Installed
The Installer places all the necessary
OMS and Studio 4 files onto your hard
disk automatically. After running the
Installer and restarting your Macintosh,
you can begin to use OMS and your
Studio 4.
NOTE: You must install the Studio 4 OMS
driver to use the Studio 4. The Studio 4
requires OMS version 1.2 or later.
Studio 4 Manual
Software Installation and Setup
See the OMS manual to learn about the
various OMS files and where they're
installed.
The Studio 4 package includes some addi-
tional files that aren't part of basic OMS:
•
•
•
CAUTION: Do not relocate or rename any
files or folders that the Installer places in
the System Folder. You may delete unneces-
sary files, but some files are essential for
OMS operation. See the Software Defini-
tions section of your OMS manual for more
information.
Although the Studio 4 works with non-
OMS applications, all programming and
setup of the Studio 4 is handled by OMS.
Studio Patches Editor —This appli-
cation adds the ability to create OMS
patches. OMS patches are discussed
in Part Three of this manual.
OMS Program Changes—This
driver allows you to change OMS
patches from Macintosh applications
and is installed in the OMS Folder
within the System Folder. See
"Sequencing Patch Changes" in
Chapter 11 for more information.
Studio 4 OMS Driver—This driver
allows OMS to operate with your
Studio 4 and is installed in the OMS
Folder within the System Folder.
19