Table of Contents
Advertisement
INSTALLATION
Step 1: Installing the battery
The Wayfinder V7000 uses a CR123 Lithium
type battery, installed according to the
diagram on the inside of the battery
compartment. Push the battery straight down
into the compartment, not at an angle. To
remove, open the battery compartment and
tap the back of the unit against the palm of
your hand and the battery will come out.
Once the battery is inserted, the unit will
go through a quality test. If the display
becomes stuck, remove the battery, wait for
approximately one minute, and then reinsert
the battery.
If the battery is the only power source,
whenever the battery is changed or removed,
the Wayfinder V7000 must be recalibrated
and all previous feature settings must be reset.
With the 12-volt adapter or the hardwire
kit installed, the battery may be removed or
changed without affecting any settings.
The Wayfinder V7000 has an auto shut-off fea-
ture. When no magnetic field change has been
detected for approximately 10 minutes, the
compass automatically switches off and saves
all settings. Note: The unit also switches on
automatically if used with the 12-volt adapter
(see next section).
8
Hide quick links:
Advertisement
Table of Contents
