WayFinder V7000 Operation Manual page 13

INSTALLATION HEADER
To install the external temperature
sensor:
1. Insert the connector end of the tether
into the jack marked "TEMP," located on
the back of the compass. The jack is
keyed for easy identification.
2. Adhere the sensor end of the tether
outside of the passenger compartment.
Make sure the mounting surface is free of
oil and dirt.
3. Use the included retainer clips to secure
the temperature tether to the windshield
or dashboard (optional).
If the temperature sensor is not plugged
in and
temperature" display, the message
"
PLUG IN TEMP CABLE
the upper right corner three times, then
will display "
Do not leave the unit in a parked vehicle
that is likely to be exposed to extremely
hot or cold temperatures.
A 30-foot (9m) temperature sensor is
available at additional cost.
Optional Accessories.
11
is toggled to "outside
" will scroll in
."
_ _ _ °F
See